Fans of handicraft must be familiar with the balsa wood. It is widely used in making
models. If you are interested in make a balsa wood plane, you can read the
article belows. Several things you should prepare before getting start the work:
balsa wood sheet, pencil, crafting knife and plastic nose propeller clip. All
these things can be purchased in a mall. Look carefully step by step and finally
you will complete your own balsa wood plane.
Step 1
According to your requirements, draw a body piece of the balsa on on the
balsa wood sheet. The plane should be designed with the length between 6 and 8
inches, and height between 1 and 2 inches. In front of the plane, a narrowed
nose should be built. Mark off a notch in the back of the body.
Step 2
Mark off a notch in the center of the front of the fin which is similar to
the notch in the body you have just made. The rear fin can be tapered depending
on your needs to narrow up front. And the rear fin is with the depth of one inch
and with about 2 to 3 inches.
Step 3
The wings should be designed as long as the body piece and as wide as the
center slot cut into the body piece. You can taper off the wing slightly just
like what you have done with the fin. Cut out the pieces of balsa wood according
to your design with the crafting knife.
Step 4
Align the notches to insert the tail fin into the balsa body of the plane and
push them together. The flat sides should be parallel to the ground when the
plane is thrown and the fin should be perpendicular to the body. Slid and center
the wing pieces through the slot cut into the body to insert the wings. The
balsa wood plane will be ready to throw after sliding the propeller clip onto
the front.
没有评论:
发表评论